A high quality, high performance and competitively price low pass filter for all 50 ohm pallet amplifiers up to and including 250W continuous power.
- 86-110MHz
- 0.30 dB insertion loss maximum; 0.25 dB typical.
- -25dB return loss maximum; -28dB typical.
- Metal clad silver teflon caps from CDE.
- #14 Awg Inductors.
- -45dB rejection at 176MHz. That's the 1st harmonic of 88MHz
- Size: 2.75 inches wide x 3.75 inches long x 0.625 high.
- Each unit is sweep tested on an HP 8753D network analyzer to meet our specifications
- .25dB maximum insertion loss, better than -20dB return loss from 88-108MHz..
- RF connectors are not included. A coax can be soldered directly or the product can be installed in an enclosure (customer supplied)
- Mounts to customers chassis with 8-32 screws. 3/8 inch PCB standoffs or washers are required between the bottom of the PCB and chassis to prevent shorting of the inductors. Installing the filter in a metal chassis is suggested to provide shielding and good thermal conductivity in high power installations.
- This low pass filter is intended for use in 50 ohm systems only.
FM Pallet Amplifiers
FM Drivers
TV Pallet Amplifiers
FM Modules
Lab Amplifiers
FM Low Pass Filters
FM Modulators
RF Combiners
Antenna Divider
RF Transistors
Accessories
TV Modulators
Repairs-Service
